angular velocity

1. If the angular velocity of a body changes, it is said to have an angular acceleration.
   如果物体的角速度是改变的，就说这个物体具有角加速度。
2. Just as linear momentum is the product of mass and velocity, so the angular momentum of a body is defined as the product of its moment of inertia and its angular velocity.
   正如线性动量是质量和速度乘积一样，物体角动量也定义为其惯性矩和角速度的乘积。
3. Impeller rotation angular velocity and flow into a linear relationship, the measured angular velocity of rotation can be measured flow value.
   叶轮的旋转角速度与流量成线形关系，测得旋转角速度就可测得流量值。
4. The envelope of the beat frequency will always be stationary in space; no angular velocity.
   信封的摆动频率将永远固定在空间；没有角速度。
5. First, according to the tracking error dynamics and kinematics described by unit quaternion error and angular velocity error, a sliding mode controller is derived based on Lyapunov theory.
   首先根据由误差四元数和误差角速度描述的跟踪误差动力学和运动学方程，设计了基于李亚普诺夫方法的滑模变结构控制律。
6. So this is a linear velocity, this is an angular velocity.
   因此这是线速度，那个是角速度。
7. A kind of control law is designed using unit quaternion and angular velocity by the feedback nonlinearization approach firstly.
   首先利用反馈非线性化方法，给出一种不含非线性扭矩项、仅由四元数和角速度的线性组合构成的控制规律。
8. Simulation results show that the angular velocity calculation precision is obviously improved by the new method.
   仿真结果表明，利用此方法能明显提高系统角速度解算精度。
9. And this is rotating around with angular velocity omega You're here& there you are.
   空间站以ω的角速度旋转，你位于这里。
10. The angular velocity compensations of carrier attitude measurement are different if the installation modes of gyros are different.
    陀螺安装的方式不同，则载体姿态的角速度补偿量也不同。
11. Traditional coning compensation algorithm error greatly increased while angular velocity signal was algorithm input.
    以角速率信号作为算法输入时，采用以往常用的圆锥补偿算法，算法误差明显增大。
12. The oblateness in each time can be calculated according to the conjectured change of the radius, the quality and the angular velocity.
    通过推测地球的半径、质量和角速度的变化量，计算出地球各个时期的扁率。
13. What is the angular velocity after the ball has made five complete revolutions?
    在球转了五整圈之后，角速度是多少？
14. In this paper, the kinematics simulation for airborne folding mechanism is firstly being made, and the formulas for calculating the crank's angular velocity and angular acceleration are obtained.
    本文首先通过对机载折叠机构做运动学分析，得出了曲柄的角速度和角加速度计算公式。
15. The actual speed is the radius times angular velocity.
    实际的速度就是半径乘以角速度。
16. The Research of Accelerometers 'Array Error Coefficient Demarcate Method Based on Angular Velocity
    基于角速率的加速度计阵列误差系数标定方法的研究
17. The tab contains a toothed wheel which is driven at a high angular velocity by the impinging airstreams.
    舵片上有一个带齿的轮，这个轮受到气流的冲击而高速转动。
18. So it has a phenomenal angular velocity.
    它有个明显的角速度。
19. Don't confuse it with angular velocity.
    不要把它，和角速度混淆。
20. The new method of measuring angular velocity of spinning projectile in exterior trajectory was proposed.
    旋转弹外弹道自转角速度的实时测量是弹道修正引信弹道解算器设计的重要环节之一。
21. Concretely, this curl gives you the angular velocity of the rotation, well, with a factor two but that doesn't matter, and the axis of rotation, the direction of the axis of rotation.
    它给出了这个旋转的角速率，有一个因子2，但没关系，给出了旋转轴，和旋转轴的方向。
22. GFSINS uses accelerometers output called specific force to replace angular velocity gyroscope and calculates the bodys angular velocity.
    无陀螺联捷惯导系统采用加速度计输出的比力代替角速度陀螺仪来解算载体角速度。
23. And angular acceleration is the derivative of angular velocity.
    角加速度等于，角速度的导数。
24. It is well known that the angular velocity of a rigid body is no relative to the basic points.
    刚体的角速度与基点无关，这是一个熟知的事实。
25. Virtual Instrument for Measuring Angular Velocity and Angular Acceleration Based on LabVIEW;
    叙述了用速度瞬心法求导杆角加速度的新方法。
26. The units are in radians per second, the same as angular velocity.
    单位都是，弧度每秒，和角速度一样。
27. The tracking angle, angular velocity and the angular acceleration can be derived through the tracking laws.
    通过该跟踪规律可以推出用户星天线跟踪中继卫星的跟踪角度、角速度和角加速度。
28. The muzzle vibration responses are the linear displacement, linear velocity linear acceleration, angular displacement, angular velocity and angular acceleration.
    炮口振动响应量包括线位移、线速度、线加速度、角位移、角速度和角加速度。
29. Torque divided by moment of inertia is going to be d over dt of angular velocity.
    扭矩除以转动惯量，等于角速度对t的导数。
30. The relations between joint torque deviation and angular velocity of manipulator are controlled.
    并能同时控制机械手抓取过程中关节力矩偏差和角速度关系。

noun

1. (physics) the rate of change of the angular position of a rotating body